Sony KLH-40X1 - Manual (Page 64)

30 GB
Specifications
Video processing
Panel system a-Si TFT Active Matrix LCD Panel
Display resolution 1,366 dots (horizontal) × 768 lines
(vertical)
Sampling rate 13.5 MHz to 140 MHz
Color system NTSC, PAL, SECAM, NTSC4.43,
PAL-M, PAL-N, PAL60
Input signal See page 29.
Pixel pitch 0.648 (horizontal) × 0.648 (vertical) mm
( 1 /
32
× 1 /
32
inches)
Picture size 885 (horizontal) × 498 (vertical) mm
(34 7 /
8
× 19 5 /
8
inches)
Panel size 40-inch (diagonal 1,016 mm)
Inputs and Outputs
HD15 (RGB/COMPONENT IN)
D-sub 15-pin (female) (× 1) (See
page 31.)
AUDIO (COMMON AUDIO IN)
Stereo mini jack (× 1)
500 mVrms, high impedance
HDMI 1/HDMI 2 IN
S VIDEO IN
Mini DIN 4-pin (× 1)
Y (luminance): 1 Vp-p ± 2 dB sync
negative, 75 ohms terminated
C (chrominance): Burst
0.286 Vp-p ± 2 dB (NTSC),
75 ohms terminated
Burst 0.3 Vp-p ± 2 dB (PAL),
75 ohms terminated
VIDEO IN Pin jack (× 1)
1 Vp-p, 75 ohms unbalanced, sync
negative
AUDIO IN Pin jack (× 2)
500 mVrms, high impedance
REMOTE (RS-232C)
D-sub 9-pin (× 1)
CONTROL S OUT
Mini jack (× 1)
General
Power requirements
90 V to 264 V AC, 50/60 Hz,
2.3 A
Power consumption
220 W
Speaker output
10 W + 10 W (8 ohms)
Adequate load impedance, 8 to 16 ohms
Operating conditions
Temperature: 0 °C to 35 °C
(32 °F to 95 °F )
Humidity: 20% to 90%
(no condensation)
Storing/transporting conditions
Temperature: –20 °C to +60 °C
(-4 °F to 140 °F )
Humidity: 5% to 95%
(no condensation)
Dimensions
989 Ч 685 Ч 270 mm
(39 Ч 27 Ч 10 5 /
8
inches)
(w/h/d, excluding projections)
Mass 28.0 kg (61.7 lb)
Supplied accessories
AC power cord (1)
Remote Control RM-FW001 (1)
Size AA (R6) batteries (2)
Cable holder (1)
HD15-Component Cable (1)
Operating instructions (1)
Safety regulations
UL 60950-1, CSA No. 60950-1-03 (c-UL),
FCC Class B, IC Class B,
EN 60950-1 (NEMKO), CE, C-Tick
Design and specifications are subject to change
without notice.
Always verify that the unit is operating properly before
use. SONY WILL NOT BE LIABLE FOR DAMAGES
OF ANY KIND INCLUDING, BUT NOT LIMITED
TO, COMPENSATION OR REIMBURSEMENT ON
ACCOUNT OF THE LOSS OF PRESENT OR
PROSPECTIVE PROFITS DUE TO FAILURE OF
THIS UNIT, EITHER DURING THE WARRANTY
PERIOD OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER REASON
WHATSOEVER.