Sony DPP-F700 - Manual (Page 35)

35 GB
U
s
ing
as
a
prin
ter
• Do not bend the print paper, or cut the print paper
from the perforations before printing.
• To avoid paper jam or malfunctions of this unit,
make sure of the following before printing:
– Do not write or type on the print paper.
– Do not attach a sticker or stamps on the print
paper.
– When adding print paper to the paper tray, be
sure that the total number of print paper sheets
does not exceed 20 sheets.
– Do not insert different types of print paper
together into the paper tray.
– Do not print on used print paper. Printing an
image twice on the same paper will not make
the printed image thicker.
– Use the print paper for this unit only.
– Do not use print paper ejected without printing.
Notes on storing the print paper
• To store print paper in the tray, remove the paper
tray from this unit and close the slide door of the
paper tray.
• Avoid storing the paper with the printed faces
touching each other or in contact with rubber or
plastic products, including vinyl chloride or
plasticizer for an extended period of time; color
changes or deterioration of the printed image may
occur.
• Avoid placing the print paper in a location subject
to high temperatures, high humidity, excessive
dust or direct sunlight.
• When you are going to store partially-used print
paper, store it in its original bag or a similar
container.
5
Insert the paper tray into this unit.
Before printing
The paper outlet opens automatically when this
unit is placed in the print position (when laid
flat), but you should make sure it is fully open
before printing.
Leave enough room around this unit. The print
paper emerges from the back a few times
during printing. Keep 10 cm (3 13/32 inches)
or more space at the rear of this unit.
AC Adaptor
Power cord
To the wall
outlet
10 cm or more
(3 13/32inches)
Movement of print paper