Sony STR-DA1ES - Manual (Page 56)

56 GB
Remote Operations Function
Button
POSITION** TV Changes the position of
the small picture.
SWAP** TV Swaps the small and the
large picture.
SUB CH TV Selects the preset
+/–** channels for the small
picture.
P IN P** TV Activates the picture-in-
picture function.
JUMP TV Toggles between the
previous and the current
channels.
WIDE TV Selects the wide picture
mode.
TV/VIDEO TV Selects input signal: TV
input or video input.
** Only for Sony TVs with the picture-in-picture
function.
Notes
• When you press the function buttons (VIDEO 1,
VIDEO 2, VIDEO 3, DVD/LD), the input mode of
the TV might not switch to the corresponding input
mode that you want. In this case, press the TV/
VIDEO button to switch the input mode of the TV.
• Some functions explained in this section may not
work depending on the model of the receiver.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
• The TV/SAT and PHONO functions are not
available for set operation.
Changing the factory
setting of a function button
If the factory settings of the FUNCTION
buttons do not match your system components,
you can change them. For example, if you have
an MD player and a tape deck and you don’t
have a CD player, you can assign the CD/SACD
button to your tape deck.
Note that the settings of the TUNER and
FN SHIFT functions (VIDEO 1, VIDEO 2,
VIDEO 3, PHONO and MD/TAPE) button
cannot be changed.
1
Hold down the Function button whose
function you want to change (for
example, CD/SACD).
2
Press the corresponding button of the
component you want to assign to the
Function button (for example, 4 – Tape
deck).
The following buttons are assigned to select
the functions:
To operate Press
CD player 1
DAT deck 2
MD deck 3
Tape deck A 4
Tape deck B 5
LD player 6
VCR (command mode VTR 1*) 7
VCR (command mode VTR 2*) 8
VCR (command mode VTR 3*) 9
TV 0
DSS (Digital Satellite Receiver) >10
DVD ENTER
VCD player .
* Sony VCRs are operated with a VTR 1, 2 or 3
setting. These correspond to Beta, 8mm and
VHS respectively.
Now you can use the CD/SACD button to
control the tape deck.
To reset a button to its factory
setting
Repeat the above procedure.
To reset all the function buttons to
their factory setting
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
Remote button description
(continued)