Sony MHC-V5 - Manual (Page 47)

47 GB
MHC-V5.GB.4-531-350- 11(1)
Additional Inf
orma
tion
ˎ
(USA model only)
One blade of the plug is wider than
other for the purpose of safety and will
fit to the wall outlet only one way. If you
are unable to insert the plug fully into
the outlet, contact your dealer.
ˎ
AC power cord must be changed only at
the qualified service shop.
On placement
ˎ Do not place the system in an inclined
position or in locations that are
extremely hot, cold, dusty, dirty, or
humid or lacking adequate ventilation,
or subject to vibration, direct sunlight or
a bright light.
ˎ Be careful when placing the system
on surfaces that have been specially
treated (for example, wax, oil, polish) as
staining or discoloration of the surface
may result.
ˎ
If the system is brought directly from
a cold to a warm location or is placed
in a very damp room, moisture may
condense on the lens inside the unit,
and cause the system to malfunction.
In this situation, remove the disc, and
leave the system turned on for about an
hour until the moisture evaporates.
On heat buildup
ˎ Heat buildup on the unit during
operation is normal and is not a cause
for alarm.
ˎ Do not touch the cabinet if it has been
used continuously at a high volume
because the cabinet may have become
hot.
ˎ Do not obstruct the ventilation holes.
On the speaker system
The built-in speaker system is not
magnetically shielded, and the picture on
nearby TV sets may become magnetically
distorted. In this situation, turn off the
TV, wait 15 to 30 minutes, and turn it back
on. If there is no improvement, move the
system far away from the TV.
Cleaning the cabinet
Clean this system with a soft cloth slightly
moistened with a mild detergent solution.
Do not use any type of abrasive pad,
scouring powder, or solvent, such as
thinner, benzine, or alcohol.
On BLUETOOTH Communication
ˎ BLUETOOTH devices should be used
within approximately 10 meters (33
feet) (unobstructed distance) of each
other. The effective communication
range may become shorter under the
following conditions.
 When a person, metal object, wall
or other obstruction is between
the devices with a BLUETOOTH
connection
 Locations where a wireless LAN is
installed
 Around microwave ovens that are
in use
 Locations where other
electromagnetic waves occur
ˎ BLUETOOTH devices and wireless LAN
(IEEE 802.11b/g) use the same frequency
band (2.4 GHz). When using your
BLUETOOTH device near a device with
wireless LAN capability, electromagnetic
interference may occur. This could result
in lower data transfer rates, noise, or
inability to connect. If this happens, try
the following remedies:
 Try connecting this system and
BLUETOOTH device when you are at
least 10 meters (33 feet) away from
the wireless LAN equipment.
 Turn off the power to the wireless
LAN equipment when using your
BLUETOOTH device within 10 meters
(33 feet).
ˎ The radio waves broadcast by this
system may interfere with the operation
of some medical devices. Since this
interference may result in malfunction,
always turn off the power on this
system and BLUETOOTH device in the
following locations:
 In hospitals, on trains, in airplanes,
at gas stations, and any place where
flammable gases may be present
 Near automatic doors or fire alarms