Sony ICD-BM1VTP2 - Manual

© 2003 Sony Corporation Printed in Japan 3-265-551-11(1)
For the customers using the optional AC
power adaptor
The optional AC power adaptor is supplied with a clamp filter.
When using the optional AC adaptor, make sure to attach the
supplied clamp filter to the cable following the procedures below.
(You must affix the ferrite cores to comply with the applicable
standards.)
1
Open the clamp filter.
2
Wind the cable into the clamp filter as show below.
Attach the clamp
filter on one end of
the cable.
3
Close the clamp filter.
As close to the
plug as possible
that is connected
to DC IN jack.
Wind the cable
one and a half
times.
Make sure the
clasps are fully
engaged.
ICD-BM1/BM1PRO