Sony SU-XTQ005 - Manual (Page 6)

4
(US)
Check the parts
Name Quantity
Table-Top Stand
1
Display securing screw
M5
×L16
4
Anchor attachment
2
Cable cover
1
Cable cover securing screw
M4
×L12
2
Be sure to have appropriate sized Phillips screwdrivers
on hand for the various sized screws used for
assembly.
Assembling the stand
WARNING
A short circuit or an electric shock may result if the
AC power cord is pinched under the footing of the
stand or between other equipment.
If you stumble over the AC power cord or the
display interface cable, the stand may topple over
and cause injury.
Decide on the installation location and lay the
stand down before installing the Display Unit.
Since the Display Unit is heavy, it is recommended
that you decide on the installation location first,
and then lay the stand down before installing the
Display Unit.
Place the stand at least 8 cm (3 1/4 inches) back
from the front edge of the shelf, and at least
10 cm (4 inches) away from the wall.
The Table-Top Stand swivels 18 degrees to the left
and right. The stand swivels on a turntable at the
bottom of the stand. If you place the stand on a
narrow shelf, a part of the stand will protrude from
the front edge, or the Display Unit will hit the wall.
This may cause serious injury or damage by falling
down.
Note
Do not drag the Table-Top Stand while it is on the floor.
The rubber footings on the base of the Table-Top Stand
may come off.
At least
10 cm
(4 inches)
At least
8 cm
(3 1/4 inches)