Adder Technology AdderView CATx EPS-S8 - Manual (Page 77)
















Advanced Options
Advanced.options.are.available.only.to.the.
Admin.user.and.consist.of.settings.that.are.
related.to.specialist.areas.such.as.power.
control.and.DDC.
Power Control
The.options.within.this.section.are.concerned.with.the.operation.of.the.
POWER
CONTROL .port.when.used.to.command.optional.system.power.control.units...
Baud Rate
Settings: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
Configures.the.communication.speed.of.the.
POWER CONTROL .port.and.must.
match.the.speed.used.by.the.connected.power.switch(es)..Note: The PSU-
8MASTER and PSU-8SLAVE power switches supplied by Adder require a setting
of 9600.
Format
Settings: NONE.8.1, ODD.8.1, EVEN.8.1, NONE.8.2, NONE.7.2, ODD.7.2,
EVEN.7.2
Configures.the.data.format.used.by.the.serial.port.and.must.match.the.format.
used.by.the.connected.power.switch(es)..The.NONE/ODD/EVEN.portion.relates.
to.the.parity.checking;.the.7/8.value.is.the.size.of.the.data.byte.and.the.1/2.
value.determines.the.stop.bit(s).used.after.each.data.byte.
continued
ADDERVIEW CATx IP
Advanced Options
DDC Options
Power Control
Setup Options 2
USB Country Code
Enter-Select
F1-More menus
Esc-Quit
Firmware Version 3.03
DDC Options
The.options.within.this.section.are.related.to.the.Display.Data.Channel.features.
supported.by.the.AdderView.CATx..DDC.is.an.industry.standard.format.that.
allows.computer.systems.to.be.informed.of.the.capabilities.of.the.video.monitor.
connected.to.them.
DDC Source
Settings: AUTO, LOCAL, DEFAULT
Determines.which.user.port.monitor.should.be.interrogated.to.discover.its.
capabilities..
AUTO.begins.with.the.local.user.port.and.if.it.fails,.it.uses.a.set.of.
default.values..The.LOCAL.setting.forces.the.unit.to.interrogate.only.the.local.
monitor.and.DEFAULT.uses.only.the.pre-programmed.settings.
DDC Refresh
Settings: AT START, DISABLED
AT START.sets.the.AdderView.CATx.to.read.DDC.information.from.the.selected.
source.at.power.up..When.DISABLED,.no.new.DDC.data.is.sought.and.existing.
information.is.used..When.viewing.this.menu,.press.F8.to.discover.DDC.
information.from.the.chosen.source.immediately..
To get here
1. From.a.local,.remote.or.global.keyboard,.
log.on.as.‘admin’.user.
2. Press. . . .(hotkeys.can.change).
3. Press. .to.select.‘More.menus’.
4. Select.‘Advanced.Options’..