Adder Technology AdderView CATx EPS-S8 - Manual (Page 91)















90
Serial port configuration
This.page.provides.all.access.to.settings.concerned.with.the.two.serial.ports.
(modem.and.power.control).that.are.situated.at.the.rear.of.the.AdderView.CATx.
IP.unit..
Modem port
PPP Server IP Address / PPP Client IP Address
When.a.user.dials.into.the.AdderView.CATx.IP.via.a.modem.or.ISDN.adapter,.the.
AdderView.CATx.IP.sets.up.a.temporary.two-device.network.using.PPP.(Point.to.
Point.Protocol)..For.this.purpose,.both.devices.must.have.‘dummy’.IP.addresses.
so.that.they.can.communicate.correctly..These.two.addresses.can.be.almost.
anything.expressed.in.the.quad.octet.format.(i.e..192.168.3.1.)..However,.it.is.
advisable.not.to.make.them.the.same.as.the.real.IP.addresses.used.by.either.the.
remote.system.or.the.AdderView.CATx.IP..
Baud Rate
This.option.configures.the.speed.of.the.serial.connection.between.the.
AdderView.CATx.IP.and.a.connected.modem.or.ISDN.terminal.adapter..The.
default.setting.is.115200..The.other.communication.settings.are.fixed.as:.No.
parity,.8.bit.word,.1.stop.bit.
Initialization Sequence
The.codes.entered.here.are.used.to.prepare.the.connected.modem.or.ISDN.
terminal.adapter.for.use.with.the.AdderView.CATx.IP..The.default.code.is.
a.Hayes-compatible.string.to.configure.auto.answer.mode.and.would.be.
understood.by.the.vast.majority.of.modem/ISDN.devices..The.code.is.sent.when.
the.AdderView.CATx.IP.is.first.switched.on.or.whenever.the.Initialize.button.is.
clicked.
Initialise
When.clicked,.this.option.sends.the.characters.entered.in.the.Initialization.
sequence.field.to.the.connected.modem.or.ISDN.terminal.adapter.
Restore Defaults
When.clicked,.this.option.resets.the.Baud.rate.and.Initialization.sequence.values.
to.their.original.default.settings.
Power control port
Baud Rate
This.option.configures.the.speed.of.the.serial.connection.between.the.
AdderView.CATx.IP.and.a.connected.power.control.unit..The.default.setting.is.
9600.as.used.by.the.majority.of.power.units..The.other.communication.settings.
are.fixed.as:.No.parity,.8.bit.word,.1.stop.bit.
To get here
1. Using.VNC.viewer.or.a.browser,.log.on.as.the.‘admin’.user.
2. Click.the.‘Configure’.button.in.the.top.right.corner.
3. Click.the.‘Serial.port.configuration’.option.