American Audio APX-152 - Manual (Page 7)

© American Audio ® - www.AmericanAudio.us - APX-152™/APX-PowerPro™ - Instruction Manual Page 7
6. RIGGING POINTS – The APX-152™ and APX-Power Pro™ each include four rigging points.
These points are to be used to “fly” or suspend the speaker in the air by some means. Be sure
to follow the “flying” outlines on page 13.
7. TRANSPORT HANDLE – The APX-152™ and APX-Power Pro™ with built-in heavy-duty trans-
portation handle. Be sure to carry the speaker by the handle for secure and easy transporta-
tion.
Rear Panel (APX-152™ Only):
8. SPEAKON CONNECTIONS – The speaker includes a pair of Speakon type connections. You
may use both connections at once to loop speakers. These Be sure to use either the Speakon
type input connector or the 1/4” Phono input connector (9), never use more than one input
connection at once. The Speakon connectors have a pin 1+ (hot) and 1- (ground) configuration,
pins 2+ and 2- are not used. For more wiring information regarding the Speakon connectors
see page 16.
9. 1/4” PHONO JACKS – The speaker includes a pair of standard 1/4” phono jacks. These jacks
are used for signal input and output. These jacks comes with a special locking clip that must
be pressed in to release the input plug, this features secures the input plug during heavy bass
response. The 1/4” jack has a tip positive and sleeve negative configuration.
10.POLE MOUNT LOCKING PIN – This pin is used to secure the speaker in place when mounting
the speaker in a pole mount configuration. Always be sure to tighten down on the locking pin
to prevent the speaker from shifting during use.
APX-152™/APX-PowerPro™ Controls and Features