Sony DSC-WX1 - Manual (Page 114)

Ta
ble
of
co
nte
n
ts
Op
e
rat
io
n
S
ear
ch
MENU/Settin
g
s
Se
ar
ch
In
de
x
114 GB
The remaining charge indicator is incorrect.
• This phenomenon occurs when you use the camera in an extremely hot or cold location.
• A discrepancy arose between the remaining charge indicator and the actual remaining battery charge.
Fully discharge the battery pack once, then charge it to correct the indication.
• The battery pack is dead (page 129). Replace it with a new one.
Cannot charge the battery pack.
• You cannot charge the battery pack using the AC-LS5K/AC-LS5 AC Adaptor (sold separately). Use
the battery charger to charge the battery.
The CHARGE lamp flashes while charging the battery.
• Remove and reinsert the battery pack, making sure it is installed correctly.
• The temperature may be inappropriate for charging. Try charging the battery pack again within the
proper charging temperature range (10°C to 30°C (50°F to 86°F)).
• Refer to page 130 for details.
Cannot record images.
• Check the free capacity of the internal memory or “Memory Stick Duo” media. If it is full, do one of
the following:
– Delete unnecessary images (page 40).
– Change the “Memory Stick Duo” media.
• You cannot record images while charging the flash.
• Movies with the size set to [1280×720] can only be recorded on a “Memory Stick PRO Duo” media.
When using recording media other than “Memory Stick PRO Duo” media, set the movie image size
to [VGA].
• Set [Demo Mode] to [Off] (page 86).
Smile Shutter function does not work.
• No image is shot if a smiling face is not detected.
• Set [Demo Mode] to [Off] (page 86).
Anti-blur function does not work.
• The anti-blur function does not work when appears on the display.
• The anti-blur function may not work properly when shooting night scenes.
• Shoot after pressing the shutter button halfway down.
Recording takes a long time.
• When the shutter speed becomes slower than a certain speed in low light conditions, the NR (Noise
Reduction) slow shutter function is activated automatically to reduce the image noise. Under such
conditions, recording takes a long time.
• The Anti Blink function is working. Reset [Anti Blink] to [Off] (page 64).
Shooting still images/movies