Sony SDM-HS74P - Manual (Page 3)

3
(US)
US
Setup
Unpacking
Make sure your carton contains everything listed below.
• LCD display
• Power cord
• HD15-HD15 video signal cable (analog RGB)
• DVI-D video signal cable (digital RGB)
• Cord strap
• CD-ROM (utility software for Windows/Macintosh, Operating
Instructions, etc.)
• Warranty card
• This Quick Setup Guide
Connecting your monitor
Connect your monitor to a computer or other equipment.
1
Remove the back cover.
2
Connect your monitor to a computer.
Connecting a Macintosh computer
Connect the supplied video signal cable to a video output connector
on the computer. If necessary, use an adapter (not supplied). Connect
the adapter to the computer before connecting the video signal cable.
3
Connect the supplied power cord to the monitor’s
AC IN connector.
4
Connect the power cord to a power outlet.
Note
For details on securing the cords, refer to the Operating Instructions on the
CD-ROM.
Turning on the monitor and
computer
Turn on your monitor first, then a computer.
1
Press upward the 1 (power) switch on the front
right of the monitor.
The 1 (power) indicator lights up in green.
2
Turn on the computer.
• Turn off the monitor, computer, and any other
equipment before connecting them.
• Do not touch the pins of the video signal cable plug.
back cover
1
HD-15 DVI-D
INPUT 1 INPUT 2
to the HD15 input
connector (analog RGB)
to AC IN
power cord
(supplied)
to power outlet
3
2
HD15-HD15
video signal
cable (analog
RGB)
(supplied)
4
to the DVI-D input
connector (digital RGB)
DVI-D video
signal cable
(digital RGB)
(supplied)
MENU OK INPUT
lights in
green