Anton/Bauer TITAN T2 User Manual
Page 9
7
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class A
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.
This equipment has been approved by one or more agencies. All changes and/or
modifications not expressly approved by Anton Bauer, Inc. could void the users’
warranty and authority to operate this equipment. There are no serviceable parts in
this equipment.
SPECIFICATIONS
Size
11.5” x 4.5” x 3.5”
Weight 2.7lbs.
(1.23kg)
Input Voltage
90-250VAC 50/60 Hz
Output Voltage*
16 VDC
Maximum Power*
70 watts at 16.4 volts
Fuse Rating
5 amp (PCB Mounted)
*IN CAMERA POWER MODE AT 4 PIN XLR CONNECTOR.
FUSE/TYPE REPLACEMENT
The fuse of the TITAN T2 is a PCB mounted device which should only be replaced
by a qualified service technician.