Avital MAXX2 - Manual (Page 15)

®2002 Directed Electronics, Inc. 15
You should place your system in Protected Valet Mode whenever
your vehicle is being fueled or washed, or whenever the passive
arming is not required for a short period. The Valet PIN code num-
ber for your system is noted on the back of this guide.
Note: To change your PIN code refer to How to Change Your PIN Code sec-
tion of this guide.
If the system was armed and a thief were to break into your vehi-
cle and begin entering codes at random in an attempt to disarm
the alarm, the system will lock out (indicated by a triple flash
sequence of the LED) and begin sounding the siren for two min-
utes. During this period the system will ignore further attempts to
enter the code. Even a correct code entry will be ignored. The siren
can be silenced and the system disarmed by pressing the or
button on the remote control two times.
NOTE: The PIN number noted on the back of this guide is your emergency
override code. Therefore, Do NOT leave the guide inside the vehicle for a
thief to find.
To Turn On Protected Valet Mode:
1. Turn the ignition key to the ON position.
2. Within 10 seconds, enter the first number in your PIN. Press
and release the Valet switch the same number of times as the
first digit in your PIN. Example: If your PIN is 2345, press the
Valet switch two times.
3. Turn the ignition key OFF.
Protected Valet Mode