ADTRAN MX2810 - Manual

DESCRIPTION
The MX2810 Power Supply Unit (PSU) is a plug-in unit
for the MX2810 chassis that provides the necessary
voltages required to operate the MX2810. With two cards
installed, the MX2810 can recover from power supply
unit or power source failure, depending on configu-
ration. There are three possible configurations and
modes of operation.
The Non-Redundant Power Mode
This mode offers no backup protection, but only requires
one source of power and one PSU.
Power Supply Recovery Mode
This mode offers backup protection in the event of power
supply card failure. This configuration uses a primary
and a backup PSU, but only utilizes one source of power.
In this mode, the MX2810 can continue operation in the
event of a power supply unit failure, without inter-
rupting service.
Power Supply and Source Recovery Mode
This mode offers a backup system for both card and
source failure. In this mode, two power supply units are
installed and are connected to two individual power
sources. This allows the MX2810 to handle any combi-
nation of power source or power supply failure. The
MX2810 is able to internally re-route the power source if
a power supply card and the opposite power source fail.
Features
The PSU has the following features:
♦ Receives unregulated power input
♦ Faceplate status LEDs
♦ Provision free plug-and-play
♦ Hot-swappable
♦ Meets the requirements for NEBS Level 3
MX2810
Power Supply Unit
CLEI: M3PQ0BHB_ _
Product P/N: 1185003L1 Issue Date: 0604
Document Number: 61185003L1-22B
TURN UP STEPS
1. Unpack the MX2810 Power Supply Unit and inspect for
damage. If damage is apparent, refer to your carrier or
supplier for remedy.
NOTE: To prevent ESD events when handling this equipment, all
personnel should utilize ESD shoes or wrist straps, or an
ESD flooring must be present.
2. Insert MX2810 PSU into one of the PSU slots. To insert,
hold the unit by the faceplate while supporting the
sides. Align the card edges to the guide grooves in the
designated PSU slot. Insert into chassis until the edge
connector seats firmly into the backplane. Lock the unit
in place by pushing in on the locking lever.
3. Verify that
PWR
(power) LED is active.
LED DESCRIPTIONS
The MX2810 PSU has LED status indicators. The LEDs
provided are
PWR
(power) and
CHK
(check). The power LED is
active when the unit is on and receiving full power. The
check LED is active when the power supply is failing or is
providing low power and needs to be checked.
COMPLIANCE
This product is intended for installation in a Restricted
Access location.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Changes or modifications not expressly approved by
ADTRAN could void the user’s authority to operate this
equipment.
Code Input Output
Power Code (PC) F C
Telecommunication Code (TC) – –
Installation Code (IC) A –
Warranty : ADTRAN will replace or repair this product within the warranty period if it does not meet its
published specifications or fails while in service. Warranty information can be found online
at
www.adtran.com/warranty .
©2006 ADTRAN, Inc. All Rights Reserved.
PRICING AND AVAILABILITY 800.827.0807
TECHNICAL SUPPORT 800.726.8663
RETURN FOR REPAIR 256.963.8722
*61185003L1-22B*
C A U T I O N !
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
HANDLING PRECAUTIONS REQUIRED.