Altinex Computer/Component Video+ Audio Dual Twisted Pair Transmitter MT115-110 - Manual (Page 12)

MULTITASKER
400-0433-003 11
6. [STA1]
This command enables automatic feedback
from the front panel. The command affects any
card with auto-feedback capability, not just the
MT115-110. The default at power on or reset is
STA0, off. For more details, see the [?Cn]
command definition.
Command Format: [STA1]
Feedback Prefix Definitions:
MT
Card model number
VR Firmware revision
GN Gain levels
EQ Equalization value
Example 1:
Command = [GAIN1=10C3]
Feedback = (GN1004C03)
GN = Gain
1004 = Levels (IN1=10, IN2= 04)
C04 = Card/Slot number
7. [STA0]
This command disables automatic feedback
from the card and front panel. The command
affects any card with auto-feedback capability,
not just the MT115-110 card.
The default at
power on or reset is STA0, OFF.
Command Format: [STA0]
8. [CLR]
This command clears the card settings and
returns it to the factory default values. The
default gain settings are 4 and the default
equalization settings are 32 for each input.
Command Format: [CLRCn]
Cn = Card ID (n = slot # from 1 to max slots)
Example:
In order to clear the card in slot 3, send the
command [CLRC3]. The card will respond with
the following feedback when complete:
FACTORY RESET COMPLETED
9. [TEST]
This command performs a series of tests on the
internal memory and displays a pass message if
successful. Otherwise, failures are indicated.
Command Format: [TESTCn]
Cn = Card ID (n = slot # from 1 to max slots)
Upon completion, the system will display the
results. This feedback will be similar to the
following:
MEMORY IC TEST RESULTS:
MEMORY IC PASS
10. [EQ]
This command displays the equalization setting
for an input and selects that input for adjustment
using the [+] and [-] commands.
Command Format: [EQmCn]
m = Input # (m = 1 or 2)
Cn = Card ID (n = slot # from 1 to max slots)
Example:
Display the equalization setting for Input 1 of C3,
then increase the equalization level by 3 from a
starting value of 12.
Send the command [EQ1C3] and the current
setting for Input 1 will be displayed.
[12]
Next, send the commands [+], [+], and [+] to
increase the setting by 3. Send the [EQ]
command again to receive new value.
[15]
11. [EQ=]
This command sets the equalization for an input
to a value specified by the user.
Command Format: [EQm=xCn]
m = Input # (m = 1 or 2)
x = Equalization level (x = # from 1 to 64)
Cn = Card ID (n = slot # from 1 to max slots)