Antari Lighting and Effects DNG-100 - Manual (Page 3)

3
items are included with your model. If any equipment is missing contact your
ANTARI dealer immediately.
Before beginning initial setup of your ANTARI Fog Cooler, make sure that there is no
evident damage caused by transportation. In the event that the unit’s housing or
cable is damaged, do not plug it in and do not attempt to use it until after contacting
your ANTARI dealer for assistance.
Setup
♦ Remove all packing materials from shipping box. Check that all foam and plastic
padding is removed, especially in the nozzle area.
♦ Attach power cord to rear of fog cooler.
♦ Place the fog cooler’s intake within six inches (15 cm) of a fog machine’s output.
♦ Plug power cord into a grounded electrical outlet. Turn power switch on rear of
unit to ”ON” position.
♦ Waiting time for cooling is approximately two minutes.
Operation
♦ ANTARI Fog Cooler’s output volume is determined by the output volume of the
fog machine to which it is attached.
♦ Your ANTARI dealer has the hoses and adapters required for an optimal
installation of the fog cooler. See the two illustrations below:
In the first example, a fog conducting hose (FT-10) is attached to a fog machine’s
output nozzle via an adapter (FTA-1 or FTA-2) and then connected to an adapter
(FTA-10) attached to the fog cooler’s intake.
In the second example, substitute the guide plate (FTA-12) with a fog conducting
hose (FT-10) that attaches to the front of the fog cooler via an adapter (FTA-11).
This configuration allows the fog cooler’s output to be guided to a desired area
without being affected by air currents generated by movement, wind, fans or air
conditioners.