Panasonic DMWMCFT5E - Manual (Page 10)

VQT4V83 (ENG)
10
4
Apply the grease (supplied).
Apply O-ring grease to clean the surface of the O-ring and replenish
the oil.
• Apply a rice-grain size of grease (supplied) evenly to the O-ring with the tip
of your finger. (Do not apply the grease with paper or a cloth. The fibers
from the paper or cloth may stick to the O-ring.)
• If there is too much grease on the O-ring, dirt and dust will stick to it
causing water to leak in. Therefore, hold the O-ring between the balls of
your finger and thumb and gently remove excess grease.
• By applying the O-ring grease thinly and evenly, the O-ring fits flexibly to
the groove of the marine case and keeps it airtight.
• The surface of the O-ring may stretch or rip, causing a water leak,
when an O-ring grease other than supplied is used, so always use
the specified O-ring grease.
5
Fit the O-ring evenly into the O-ring groove.
Check the following:
• There is no dirt sticking to the O-ring.
• The O-ring has not come out.
• The O-ring is not twisted.
• The O-ring is not stretched too much.
CORRECT
INCORRECT
DMW-MCFT5_PP&E-VQT4V83.book 10 ページ ２０１３年１月１６日 水曜日 午前１１時３５分