Panasonic ESLA93 User Manual

Page 10

Advertising
background image

GB

10

English

If the status lamp blinks or glows

Follow the steps outlined below if the status lamp blinks or
glows during the “Clean/Dry/Charge” course.

Blinks

Glows

Correctly set the
detergent cartridge
and then restart a
course.

Remove the shaver from the self‑
cleaning recharger and then check
that the [CLEAN] lamp has gone
out. (Be careful as the blade may
be hot or wet.) Check that the
water tank is correctly attached,
the water tank cap is securely
closed and the self‑cleaning
recharger is placed horizontally.

If the status lamp
goes out

Continue a course.

When an abnormality
has been corrected

When no abnormality was found

Press and hold
[SELECT] for 
seconds to turn off the
status lamp and then
restart a course.

It is time to replace the detergent
cartridge and cleaning liquid
inside the water tank.
Wash away the old cleaning
liquid and then rinse the water
tank. Restart the course.

When the status lamp
goes out

When the status lamp glows
again

Continue a course.

Contact an authorized service
center.

Cleaning the shaver without the self-cleaning
recharger

We recommend that you clean your
shaver with the self‑cleaning recharger or
the “sonic” vibration turbo‑cleaning mode
when the faucet symbol

appears on

the LCD panel.
1. Disconnect the power cord from the

shaver.

. Apply some hand soap and some

water to the outer foil.

3. Slide the switch lock button downwards

to unlock the OFF/ON switch.

. Press the OFF/ON switch for more

than  seconds to activate the turbo
mode for “sonic” vibration cleaning.

appears on the LCD panel.

After about 0 seconds, it will be
automatically turned off, or you can
turn it off by pressing the OFF/ON
switch.

5. Remove the outer foil section and

press the OFF/ON switch for more
than  seconds to activate the turbo
mode for “sonic” vibration cleaning and
clean it with running water.

6. Wipe off any drops of water with a dry

cloth.

7. Dry the outer foil section and the

shaver completely.

8. Attach the outer foil section to the

shaver.

9. Lubricate the shaver.


4

7

5

7

Advertising