Panasonic TYTP65P30K - Manual (Page 28)

28
English
Note
• Place the touch panel making its front surface face down on a clean cloth or blanket to prevent the front
surface of the touch panel from getting scratched or dirty during work.
Mounting in horizontal posture
Attach the mounting brackets A (for top and bottom sides) to the touch panel with the mounting screws A (2 each).
See the fi gure below for the screw holes of attachment positions.
Attachment positions
(8 holes without screws in them)
Mounting in vertical posture
Check in the fi gure below the positions where the brackets are attached, and remove the screws (8 in total from top and bottom sides).
Attach the mounting brackets A (for top and bottom sides) with the mounting screws A (2 each) to the screw
holes from which the screws were removed.
Notes
• For screw holes of other models than 42V, see “Drawing of Screw Holes” (page 33).
• Keep the screws which were removed.
The procedure for vertical posture is the same.
Touch Panel Assembly
1 2 3 4 5 6
Mounting screw A
Mounting
bracket A
(for top side)
Top side (42V)
Bottom side (42V)
1 2 3 4 5
Mounting screw A
Mounting
bracket A
(for bottom
side)