AMX AXB-MIDI - Manual (Page 12)

Programming
8 AXB-MIDI MIDI Interface
IN A and IN B MIDI Signal Routing
The following table shows all routing value possibilities for IN A and IN B incoming MIDI signals
in relation to the AXB-MIDI rear panel connectors. The value determines where the IN A and IN B
MIDI signals will be routed.
Inputs are controlled as Channels 1 through 8.
AXB-MIDI Send_Commands (Cont.)
Command Description
RXOFF
The AXB-MIDI will not pass
on received characters to the
Central Controller. This is the
default.
Syntax:
'RXOFF'
Example:
SEND_COMMAND <device>,'RXOFF'
Turns IN A and IN B transmit to the Central Controller off.
TXCLR
Clear all characters waiting in
both transmit buffers (MIDI
THRU and MIDI OUT).
Syntax:
'TXCLR'
Example:
SEND_COMMAND <device>,'TXCLR'
Clears THRU and OUT transmit buffers.
TXTHRUCLR
Clear characters waiting in
the MIDI THRU transmit
buffer.
Syntax:
'TXTHRUCLR'
Clear characters waiting in the MIDI THRU transmit buffer.
Example:
SEND_COMMAND <device>,'TXTHRUCLR'
Clears THRU transmit buffer.
TXOUTCLR Syntax:
'TXOUTCLR'
Clears characters waiting in the MIDI OUT transmit buffer.
Example:
SEND_COMMAND <device>,'TXOUTCLR'
Clears OUT transmit buffer of all contents.
IN A and IN B Signal Routing
Value THRU OUT AXlink
0
1 X
2 X
3 X X
4 X
5 X X
6 X X
7 X X X
The power-up default value is 3.