Scarlett SC-338S - Manual (Page 5)

www.scarlett-europe.com SC-338S 5
CAUTION: If the steam iron has been used for a long time, is hot and there is no water. Do not refill it with water until
the steam iron has cooled down.
BURST OF STEAM
· The burst of steam feature provides additional steam for removing stubborn wrinkles.
· Turn the temperature control dial to the MAX or position.
· Turn the variable steam control to the maximum position.
· Press the powerful steam button to release the burst of steam.
NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button pressed for more than 5
seconds.
NOTE: For the best steam quality, do not use more than three successive bursts each time, because the iron will
cool.
VERTICAL STEAM
· Ensure that there is enough water in the water tank.
· Stand the steam iron on its heel rest on an iron-safe surface and plug it.
· Set the temperature control dial and variable steam control to their maximum positions.
· Hold the iron vertically and press the steam burst button, an intense steam will be ejected from the soleplate.
ANTI-DRIP FUNCTION
· In this case the anti-drip function automatically activates to prevent vaporization, so that you may iron the most
delicate fabrics without the risk of spoiling or staining them.
ANTI-CALC FUNCTION
· Your steam iron has anti-calc function that protects your appliance from scale.
· A special filter inside the water reservoir softens the water and prevents scale build-up in the plate. The resin filter
is permanent and does not need replacing.
WHEN YOU FINISHED IRONING
· Pressing (-) button switch iron off.
· Remove the mains plug from the wall socket.
· Stand the iron on heel rest.
AUTOMATIC SHUT OFF
· The automatic shut off device trips after the iron has been left for approx. 8 minutes in the upright position or
unused for approx. 30 seconds in the horizontal position and beeps will sound till you move the iron to restart
working or unplug it.
CARE AND CLEANING
· Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled down.
· Do not use abrasive cleaners.
SELF-CLEANING
· Fill water reservoir up to the maximum level and then close it.
· Set the temperature control to its maximum position.
· Insert the main plug into the wall socket.
· Holding the iron horizontally over the sink, change the steam control to the self-cleaning position.
· Boiling water and steam will be ejected from the holes in soleplate with Impurities washed out. Rock the iron
forwards and backwards during this operation.
· Repeat self-cleaning if you notice that much impurity has been washed out.
· Move the iron over an old (preferably) piece of cloth. This to ensure that the soleplate will be dry during storage.
· Unplug the steam iron.
STORAGE
· Unplug the appliance from the power supply, empty the water tank (do it after each use) and allow steam iron cool
down completely.
· Wrap the cord around the heel rest.
· To protect the soleplate, place the steam iron in an upright position on its heel rest.
RUS
·
. ,
.
· , ,
, .
· . .
· .
· .
· , .
· , .
· , ,
.
· , ,
, .