Panasonic TYST65PV500 - Manual (Page 4)

4
Cable binding instructions
Preventing the plasma television from failing over
Tip-prevention parts
Tap screws (4) Wood screws (4) Bands (4)
Attaching to a TV stand Attaching to a wall
1
2
3
Notes:
• Securely attach to a wall, pillar or similarly solid
structural feature using separately- obtained
products such as cords or chains of adequate
strength.
• Secure in the side at two locations each on the
left and right.
Note:
There are four holes in the base for the screws holding the
bands.
Front face
Locate the wood screw at the
centre of the material width.
The picture shown is illustrative purposely only and may differ slightly from the actual product.
3
Remove the cable cover set screws on the
plasma television (used for transport).
4
Remove the cable cover from the plasma
television.
Press the two hooks (right and left) at the cover top, and then
pull the cover forward to remove it.
5
Attach the clampers to the fl oor-mounted
stand.
Attach the stand clampers (right and left).
6
Connect the cable and power cord.
7
Use the clampers to bind the cable and
power cord.
8
Reattach the cable cover to the plasma
television.
Insert the two clips into the cover bottom, and then insert the
top hooks.
■ Attaching and removing the cable cover
Removal Fitting
Cable cover set screws
Cable Power cord
Clampers
English
TY-ST65PV500_689.indb 4 TY-ST65PV500_689.indb 4 2005/09/13 10:47:00 2005/09/13 10:47:00