Panasonic ERGC70 - Manual (Page 6)

6
English
Cleaning
Cleaning with brush
1. Disconnect the power cord from the
clipper.
Be sure to set the switch to “0” before you
remove the blade.
2. Remove the comb attachment.
3. Hold the main body, place your thumb
against the blades and then push
them away from the main body.
•
4. Brush off any hair trimmings from the
main body and from around the blade.
5. Brush any hair trimmings out from
between the stationary blade and the
moving blade while pressing down
the cleaning lever to raise the moving
blade.
Cleaning in water
The mark on the left means suitable for cleaning under
an open water tap.
Warning
Disconnect the power cord from the clipper before cleaning
it in water to prevent electric shock.
1. Disconnect the power cord from the
clipper.
2. Remove the blade.
3. Rinse off any hair trimmings that are
sticking to the blades with running
water.
4. Rinse out any hair trimmings that are
inside the clipper with running water.
5. Gently shake the clipper 4 or 5 times and then wipe off
any water drops from the clipper and the blade.
6. Place the clipper on a towel with the power switch on
the main body facing downwards to let it dry fully.
Lubrication
Apply the oil to the clipper before and
after each use.
Apply a drop of the oil to the points
indicated by the arrows.
Remounting the blade
Fit the mounting hook into
the blade mounting on the
clipper and then push in until
you hear a click.