Panasonic EH1771 - Manual (Page 3)

3
English
Heating the curling iron
1. Plug the power cord into the power outlet.
2. Turn the on/off switch to “1” or “2”. (The power indication
becomes red.)
 Allow approx. 1 minute for the curling iron to heat.
 Select “1” for a low temperature to make soft curls. Select “2”
for a high temperature to make tight curls.
 Invisible negative ions are released.
Curling techniques
Before curling
1. Straighten your hair.
2. Moisten your hair lightly with styling products, water or a
steaming towel.
 When using a styling product, spray it uniformly on your hair
from a distance of approximately 10 cm so that the surface
and inside of your hair become slightly damp.
 The curling iron will not work effectively on wet hair.
1. Take about a 5 cm wide strand of hair. Hold the curling iron
vertically against the strand of hair with the press plate on the
outside and then open the press plate.
 Take only as much hair as the length of the press plate can
hold.
2. Place the strand of hair at the base of the curling iron. Roll the
curling iron inwards towards your face and then hold it in place
for 10 seconds.
 Be sure to keep the press plate at least 3 cm away from your
skin.
 Be careful not to split the ends of your hair.
3. Open the press plate and then slide the curling iron downwards
to keep the curls in place.
Basic curls (Inside spiral curls)
1 2 3
�
1
�
2 3
Instructions for use the hair band
The barrel and press plate are extremely hot and will burn you if
they touch the skin. Always wear the hair band provided when
using the appliance.
1. Place the hair band around your shoulders. (Position so that the
large piece of hook-and-loop tape  can be seen hanging from
your left shoulder.)
2. Use hairpins  to hold your bangs up, and then attach the
hook-and-loop tape so that your neck, ears and forehead are
covered by the hair band.
3. Remove hairpins.
EH1771_EU.indb 3 2006/10/03 9:59:17