Ativa 061506-5OD - Manual (Page 2)

2
ON/OFF
Maintain
Reverse Forward
ON/OFF
Maintain
Reverse Forward
ON/OFF
Maintain
Reverse Forward
Powering ON (Some Models)
The master power switch is located on the rear of
the shredder head. When the switch is turned on,
the LCD displays all of the operating functions
and gives a beep (See figure on left). Two sec-
onds after the characters are shown, the display
clears and enters the standby mode.
ON Mode
When pressing the ON/OFF button for more that
three seconds, the LCD shows AUTO and enters
AUTO mode. In the AUTO shredding mode, the
shredder stands ready to shred paper, If there is
any paper stuck at the throat in the shredder, the
shredder will automatically shred the paper. The
shredder will stop after the paper is completely
shredded.
OFF Mode
When pressing the ON/OFF button for more that
three seconds, the shredder will beep once and
shut off all functions, entering into standby
mode, the LCD will turn off. If you wish to restart,
press and hold ON/OFF button for more than
three seconds to start.
REVERSE Mode
When pressing the REVERSE button, LCD shows
the character of REVERSE and the motor enters
the REVERSE mode. Press and hold the REVERSE
button in order to keep the motor running in
reverse. When the REVERSE button is released,
the motor will stop. If there is any paper left at
the throat, the shredder will enter into the AUTO
shredding mode and the display will show AUTO.
REVERSE Mode, when shredding in AUTO mode
During forward shredding, if the REVERSE button
is pressed, the motor will stop immediately. After
three seconds, the motor starts reversing while
the LCD shows REVERSE. Pressing the REVERSE
button will keep the motor running. The shredder
will not stop until the button is released. After
the motor stops, if there is still paper remaining
in the throat, the shredder will resume AUTO
shredding and the LCD will display AUTO.
061506_OD LCD Manual 6/15/06 4:57 PM Page 2