Panasonic TYWK5P1RW - Manual (Page 7)

7
English
7
3. Installing the wall-hanging bracket on
the wall
Notes
• If it is necessary to embed screws or nuts in the wall prior to
installing the wall-hanging bracket because the wall is made of
concrete or such other materials, determine the positions of the
holes by fitting the actual wall-hanging bracket or calculating from
the figures shown in the outline drawing, and then embed screws
or nuts with a nominal diameter of 6 mm (0.2 inches) or their
equivalent.
If you are embedding the screws, make sure they protrude from
the wall surface by 10 to 15 mm (0.4 to 0.6 inches).
• For installing the wall-hanging bracket onto the wall, use screws
with a nominal diameter of 6 mm (0.2 inches) or their equivalent
available from a hardware store and suited to the materials of the
installation area on the wall.
• Anchor the screws in at least six locations.
Arrows

Angle adjustment screws
 Install the wall-hanging bracket so that the arrows indicated
on it are pointing upward.
 First of all, secure the screw in the upper center hole .
 Use a level to ensure that the bracket is not inclined at an
angle, and screw the bracket into position using the three
screw holes at the bottom.
 Remove the angle adjustment screws from the bracket base
left and right fittings  and , and open the bracket base
left and right fittings  and .
 Screw the bracket into position using the screws at the
remaining two screw holes at the top.
 Use the angle adjustment screws, which were removed, to
perform the angle adjustment of step 4.
4. Adjusting the angle of the wall-hanging bracket
 The angle of this wall-hanging bracket can be adjusted in 5-degree increments to one of five positions ranging
from “Zero tilting” to “20-degree tilting”.
The wall-hanging bracket is shipped from the manufacturing plant in the “Zero tilting” angle position. To change
the angle, use the angle adjustment screws to change the position of the stay.
(Tightening torque: 1.2 to 1.5 N•m)
“20-degree tilting”
“Zero tilting”
“15-degree tilting”
“10-degree tilting”
“5-degree tilting”
Stay
“Zero tilting”
Tilting from 5 to 20
degrees
When the angle is set to
“Zero tilting”
When the angle is set to
“15-degree tilting”
Angle
adjustment
screws
Surface of wall
Surface of wall
Note
• When using some types of HDMI cables or PC cables, the cable may touch the wall and cause damage to the HDMI
terminal or the PC input terminal on the television set.
In such a case, adjust the angle of the wall-hanging bracket so that no weight is applied to the cable.