Alpine CDM-7871 - Manual (Page 9)

7
-EN
Setting the Treble Control
You can change the Treble Frequency emphasis
to create your own tonal preference.
1
Press the TREBLE C. to turn on the Treble
setting mode.
2-1
Setting Treble frequency:
Press g DN or f UP button to select the
desired Treble center frequency.
10kHz
↔
12.5kHz
↔
15kHz
↔
17.5kHz
Emphasizes the displayed Treble frequency
ranges.
2-2
Setting Treble Level:
Press the 55555 or 66666 button to select the desired
Treble Level (-7~+7).
You can emphasize the treble frequency.
NOTES
• If no buttons are pressed within 5 seconds, the Treble
control setting will be turned off automatically.
• The settings of the Bass and Treble will be individually
memorized for each source (FM, AM and CD) until the
setting is changed. Depending on the connected
devices, some functions and display indications do not
work.
Changing Audio Level Display
Pattern
1
Press DISP button to switch the display pattern.
DISP1:
Lights the Volume indicator and Audio Level
indicator.
DISP2:
Lights the mode and value bars to show the
settings in the Bass engine display.
NOTE
The last mode set will remain in effect. The mode and
value bars light and show the Bass engine setting.
→
DISP1
→
DISP2
→
DISP OFF
Audio Level indicator
Volume indicator
Example setting:
Bass center frequency:
100 Hz
Bass band width: WIDE1
Bass level: -6
DISP OFF:
Turns off the light in Bass engine display.
If you set DISP OFF, the Volume indicator, Audio
Level indicator, and Bass engine displays are
not lit at all times.
To light them, press the DISP button to exit DISP
OFF.
NOTE
If no buttons are pressed within 5 seconds, the display
will return to normal mode automatically.
Setting the AUX Mode
You can input TV/video sound by connecting an
optional "M-Bus V-Link" (M-Bus/RCA interface
cable KCM-122B) to this component.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the g DN or f UP button to select
the AUX mode.
3
Press the BAND button to toggle the mode
between AUX ON and AUX OFF.
4
Press the SETUP button to return to normal
mode.
5
To adjust the volume, etc., first press the
SOURCE button and select the AUX mode, then
make the necessary adjustment.
→
TUNER
→
CD
→
AUX
NOTE
When AUX ON is selected, a CD Changer cannot be used.