Panasonic KXTGA750EX - Manual (Page 5)

5
Battery installation/Battery charge
(page 2: 2)
Important:
• Use the supplied rechargeable batteries. For replacement, we recommend
using the Panasonic rechargeable batteries noted in the base unit’s operating
instructions.
• Wipe the battery ends (S, T) with a dry cloth.
• Avoid touching the battery ends (S, T) or the unit contacts.
• Confirm correct polarities (S, T).
• USE ONLY Ni-MH batteries AAA (R03) size.
• Do NOT use Alkaline/Manganese/Ni-Cd batteries.
Place the handset on the charger for about 7 hours before initial use.
Note:
• The handset display may show “Please wait for 1 minute.” when the
handset is placed on the charger if it is not registered to the base unit.
• If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends ( S , T ) and the charge contacts with a dry cloth and
charge again.
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {ic} for
few seconds to turn the handset on.
1 Handset:
Lift the handset and press {ic}.
2 Base unit:
Proceed with the operation for your model.
N
KX-TG7511
Press and hold {x} for about 5 seconds. (No registration tone)
N KX-TG7521
Press and hold {x} for about 5 seconds, until the registration tone sounds.
• If all registered handsets start ringing, press the same button to stop. Then
repeat this step.
When the language selection is displayed after installing the batteries for the
first time, you can select your desired language.
{V}
/{^}: Select your desired language. i M i {ic}
TGA750EX(ex).book Page 5 Friday, January 15, 2010 6:00 PM