Panasonic KXTGA910EX - Manual (Page 6)

6
Connections
• The AC adaptor must remain connected at all times. (It is normal for the
adaptor to feel warm during use.)
Location
• For maximum distance and noise-free operation, place your base unit:
- away from electrical appliances such as TVs, radios, personal computers
or other phones.
- in a convenient, high and central location.
Battery installation
Important:
• Wipe the battery ends (S, T) with a dry cloth.
• When installing the batteries, avoid touching the battery ends (S, T) or
the unit contacts.
Battery charge
Place the handset on the charger for about 7 hours before initial use.
• While charging, the charge indicator on the handset lights in amber. When
the batteries are fully charged, the charge indicator lights in green.
Note:
• The handset display may show “Please Wait...” when the handset is
placed on the charger if it is not registered to a base unit.
• If you fully charged the batteries, but the operating time seems to be short,
wipe the battery ends (S, T) and the unit contacts with a dry cloth.
Registering the handset to the KX-TG9120/KX-
TG9140/KX-TG9150 base unit
Ensure that the handset is switched on. If it is not on, press and hold {ih}
for few seconds to turn the handset on.
1 Lift the handset and press {ih} to put the handset in standby mode.
2 Press and hold {x} on the base unit for about 3 seconds, until the
registration tone sounds.
3 Place the handset on the base unit. The registration tone continues to
sound. With the handset still on the base unit, wait until a confirmation
tone sounds and w stops flashing.
TGA910EX(ex).book Page 6 Thursday, August 3, 2006 7:07 PM