Nilfisk-ALTO 3.4 PC - Manual (Page 7)

6
4. GETTING STARTED
4.1 Configuration of the System
1 . 0
Meanwhile, the system will restore the exact operating conditions at the time of switching off.
Click the SEL key to select proper PRESET or ID status.
r user When PRESET LED lit, you can use the UP and DOWN keys to select factory PRESETs (1 ~ 10) o
PRESETs (1. ~ 64.), then you will find the data on LCD twinkling all the while.
The factory programmed, cannot be permanently changed. These include all the system's usable configurations.
For further detail, please refer the "Factory Preset Configuration" on application section.
Via the PC editor software, the user PRESETs can be programmed by users.
1
(Example: Factory PRESET)
6 4 .
(Example: User PRESET)
all When ID LED lit, the LCD will display the ID number, there are total 32 IDs, and the data twinkling the while.
Press ENTER, the display shows the PRESET/ID loaded in the units memory.
4.2 Memory Initialization
A l .
4.3 Communication
C g
4>. In this case the display show S. with the ID LED on if the machine is initializing the SETUP memory area, if the
display shows nn. with both the PRESET and ID LEDs on the machine is initializing the SETUP and PRESET
nn memory areas.
3>. If a power failure occurred while the machine was saving some data to memory, the memory is partially initialized
to avoid inconsistent data that could cause the machine to behave improperly.
2>. At turn-on the display shows AL. With both the PRESET and ID LEDs on while a complete memory initialization
is in progress.
1>. To activate the MEMORY PUFF function the SEL & UP keys must be activated and kept down during turn-on.
At first, switch off the equipment, carry out the audio and power connection from the various components of your
sound system.
S .
Then, connect the main cord and only switch on the MAXIDRIVE3.4 PC. The display will show the data regarding
with the operating system release for a few seconds.
1>. When the MAXIDRIVE3.4 PC is connected by its RS232 port to a PC running the MAXIDRIVE3.4 editor, the
display shows CG (Comm. Gateway).
.