Installing the shoulder strap, Control panel – Panasonic EY7880 User Manual

Page 8

Advertising
background image

- 8 -

Depth gauge

Depth of drilling

Installing the Shoulder Strap

CAUTION:

• Install the shoulder strap firmly to

the main unit of the tool and check

the length of the strap before use.

• Check the condition of the strap

and do not use if it is cut or torn etc.

There is a risk of injury or damage

if used while improperly installed.

• Please wear the shoulder strap se-

curely on the shoulder.

There is a risk of injury or damage

if it is accidentally dropped.

1. Pass the strap through the strap

holders.

2. Pass the strap through the buckles

and adjust the length.

Shoulder pad

Follow the instructions below in order

to avoid injury.
• The shoulder strap can be adjusted

according to the individual.

• Adjust the shoulder pad to the shoulder.

• Pull the shoulder strap to make sure it is

firmly attached to the main unit of the tool.

Control panel

(1)

(2)

(3)

(1) Battery low warning lamp

Off (normal
operation)

Flashing (No charge)
Battery protection
feature active.

Excessive (complete) discharging of Li-

ion batteries shortens their service life

dramatically. The driver includes a battery

protection feature designed to prevent

excessive discharging of the battery pack.

• The battery protection feature ac-

tivates immediately before the bat-

tery loses its charge, causing the

battery low warning lamp to flash.

• If you notice the battery low warn-

ing lamp flashing, charge the bat-

tery pack immediately.

(2) Overheat warning lamp

Off (normal

operation)

Flashing: Overheat
Indicates operation has
been halted due to motor
or battery overheating.

The overheating protection feature

halts driver operation to protect the

motor and battery pack in the event

of overheating. The overheat warning

lamp on the control panel flashes

when this feature is active.
• If the overheating protection feature

activates, allow the driver to cool

thoroughly (at least 30 minutes).

The driver is ready for use when the

overheat warning lamp goes out.

• Avoid using the driver in a way that

causes the overheating protection

feature to activate repeatedly.

NOTE:

• In summer or in other situations

where the temperature is high, the

overheating protection feature may

activate and prevent continual use.

Advertising