D (fig. 2), Fig. 2), Fig. 3) – AMX Rough-In Box CB-TP17 User Manual
Page 2: Fig. 3, X (fig. 3)
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
10/08
©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-034-10
REV: B
FIG. 2 CB-TP17 Rough-In Box installation into a notched stud (showing before and after installation)
FIG. 3 Screw locations for Rough-In Box attachment in a pre-wall installation
Mounting
tabs flush on
17.07"
~14" to 16"
the OUTSIDE
of sheetrock
13.554"
(34.43 cm)
(43.36 cm)
Before
After
Use a block to secure the
Rough-In Box to the
notched stud
Horizontal
support beam
Notched stud
Knockouts should be located on
Inserted block bridges the gap
Stud fastening holes
Mounting tabs for
NXD Wall Mount panel
Use four #8 flat-head Mounting
should be flush
with the outside
Stud
of the sheetrock
Screws to secure the NXD
to the Rough-In Box
Rough-In Box can be
fastened to both
studs)
between the Rough-In Box and
the notched beam
Secure Beam to block
Depth depends on the
thickness of the Drywall
Drywall/sheetrock
the left-side of the Rough-In Box,
alongside the connectors