Ultra Start 80 Series - Manual (Page 20)

SYSTEM PROGRAMMING - Menu 1
PAGE 20
80 SERIES
OWNER'S MANUAL
SHOCK SENSOR
The ANTENNA icon indicates the signal strength between the remote and the vehicle. If the vehicle is
out of operating range when a button is pressed the ANTENNA icon will disappear from the LCD.
The KEY icon is displayed on the top of the LCD when the remote starter is activated. When the
runtime expires this icon will turn off.
The SIREN icon indicates that the alarm has been activated, the LCD will also display the hammer or
unlock icon depending on the input that triggered the alarm. ALARM MODELS ONLY.
The TRUNK icon will be displayed on the LCD when the TRUNK RELEASE output is activated. The
icon will turn off when the next function is activated or with STATUS update.
The BATTERY icon indicates the power level of the battery. Replace the battery once two of the bars
have disappeared.
The TIMER icon is displayed in conjunction with the TIMER MODE/ COLD START MODE. When the
icon is on the system is set to start at the preset time/temperature.
Pressing the # button at any time will update the status on the remote. Hold the # button to enter
REMOTE PROGRAM MODE.
REMOTE PROGRAMMABLE FEATURES
To turn a programmable feature on or off, press and hold the # button until the 24h icon begins to
flash. Press and release the lock button until the desired icon begins to flash. Press the unlock
button to turn the feature OFF or press the star button to turn it ON. When done press # to
?
When the TIMER icon is on at the bottom of the LCD the vehicle is set for COLD START or TIMER
MODE. If this icon is turned on by remote the system will start at the last manually programmed cycle.
The PHONE icon at the bottom of the LCD indicates the status of the PAGER MODE. When the Icon is
on the status is checked every 15 seconds. When off the status is updated by pressing #.
The small KEY icon at the bottom of the LCD indicates that a fault is preventing the remote starter from
activating. Count the park light flashes then refer to the DIAGNOSTICS CHART.
The small HORN icon at the bottom of the LCD indicates the status of the Horn/ Siren chirp feature. If
the icon is ON the system will chirp as confirmation of a function. For no chirp turn the icon OFF.
The HAMMER icon is displayed at the bottom of the LCD on ALARM MODELS as an indication of the
status of the Shock Sensor. If on the Shock Sensor is active. Turn off to disable the Shock Sensor.
The Question Mark icon indicated the status of the SERVICE MODE feature. When the icon is on the
system is disabled from remote starting and all alarm functions will be turned off.