Panasonic ER2061 - Manual (Page 3)

English
3
Charging the trimmer
Char
ge
You can fully charge the trimmer in 8 hours if it is losing speed.
A full charge supplies enough power for approximately 50
minutes of use.
1. Insert the appliance plug into the
trimmer.
2. Plug in the adaptor into a
household outlet.
The charge indicator lamp lights and
stays on until the adaptor is removed
from a household outlet. •
Cord Trimming
If you insert the appliance plug to the trimmer and plug in the
adaptor into a household outlet, you can use it even if the battery
capacity is low.
If the trimmer does not work, continue charging it for approx. 1
minute. •
•
Using the trimmer Use
Trimming your beard and moustache
1. Apply a few drops of the oil to the blades.
(See page 4.)
2. Turn the dial to move the comb attachment
to the desired trimming length (between
2 mm and 18 mm).
Indicator
Trimming
length
Indicator
Trimming
length
1 2.0 mm 7 10.5 mm
2 3.0 mm 8 12.0 mm
3 4.5 mm 9 13.5 mm
4 6.0 mm 10 15.0 mm
5 7.5 mm 11 16.5 mm
6 9.0 mm 12 18.0 mm
3. Slide the switch on the main body upwards to turn on
the trimmer.
4. Place the angled face of the comb
against the skin and cut the beard by
moving the trimmer in all directions to
obtain a uniform cut.
With curly facial hair, the comb attachment
may not cut all of the hair. In this case,
remove the comb attachment and use a
conventional comb to draw out the
remaining uncut hair. •
►