Panasonic SCPT860 - Manual (Page 6)

6
Si
mp
le
S
etu
p
Po
s
it
io
n
in
g
RQ
TX00
98
ENGL
ISH
Caution
≥ Do not touch the front netted area of the speakers. Hold by the sides.
e.g. Center speaker
≥ Do not stand on the base.
Be cautious when children
are near.
∫ Attaching to a wall
You can attach all of the speakers (except subwoofer) to a wall.
≥ The wall or pillar on which the speakers are to be attached
should be capable of supporting 10 kg per screw. Consult a
qualified building contractor when attaching the speakers to a
wall. Improper attachment may result in damage to the wall and
speakers.
1 Drive a screw (not included) into the wall.
2 Fit the speaker securely onto the screw(s) with the hole(s).
∫ Fitting speaker stands
(not included)
[PT560] Center and surround speakers only
[PT860] Center speaker only
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance
between screws as shown in the diagram.
≥ The stands must be able to support over 10 kg.
≥ The stands must be stable even if the speakers are in a high
position.
e.g. Center speaker
∫ Reattaching the speaker cable
Caution
≥ The main unit and supplied speakers are to be used only as
indicated in this setup. Failure to do so may lead to damage to
the amplifier and/or the speakers, and may result in the risk of
fire. Consult a qualified service person if damage has occurred
or if you experience a sudden change in performance.
≥ Do not attempt to attach these speakers to walls using
methods other than those described in this manual.
DO
DO
NOT
DO
NOT
e.g. Front speaker
Speaker installation options
‰7.0 mm to 9.4 mm
4.0 mm to 6.0 mm Wall or pillar
‰4.0 mm
At least 30 mm
Center speaker
190 mm
[PT560] Surround speaker
In this position,
the speaker will
likely fall if moved
to the left or right. Move the speaker
so that the screw
is in this position. e.g.
DO
DO
NOT
[PT560] Front speaker
[PT860] Front and surround speakers
Attach to a wall without the base and
the stand
384 mm
116 mm
Speaker stand
(not included)
Plate thickness plus
7.0 mm to 10 mm
5.0 mm, pitch 0.8 mm
Metal screw holes
For attaching to
speaker stands
60 mm
Insert the cable from
the bottom.
Pull out the cable
through the hole. Leave about
80 mm
6
SC-PT560_860E-RQTX0098-R_eng.book Page 6 Tuesday, December 4, 2007 9:02 AM