AMD GA-M61P-S3 - Manual (Page 67)

Appendix - 67 -
English
To read more information about the RAID array, press ENTER to enter the Array Detail screen (Figure
9), where you should see detailed information about RAID mode, disk block size, disk model name,
and disk capacity, etc.
Figure 9
Figure 8
After that, the Array List screen displaying the RAID array you created will appear (Figure 8).
(Note: BBS stands for BIOS Boot Specification. This indicates that the boot device is defined in the
BIOS.)
To delete the array, press D in the Array Detail screen. When the "Delete this array?" message appears,
press Y to confirm or N to cancel. Press ENTER to return to the Array List screen.
To exit the Nvidia RAID utility, press ESC in the main menu or Ctrl+X in the Array List screen.
Now, you can proceed to install the SATA controller driver and operating system.
Array 1: NVIDIA STRIPE 233.57G
- Array Detail -
RAID Mode: Striping
Striping Width : 2
Striping Block: 64K
Port Index Disk Model Capacity
1 0 ST3120026AS 111.79GB
2 1 ST3120026AS 111.79GB
[R] Rebuild [D] Delete [C] Clear Disk [ENTER] Return
MediaShield Utility Aug 21 2006
- Array List -
[Ctrl-X] Exit [ ] Select [B] Set Boot [N] New Array [ENTER] Detail
Boot Status Vendor Array Model Name
BBS Healthy NVIDIA STRIPE 223.57G