American Acoustic Development THE CUB CUB AG-100 - Manual (Page 6)

PANEL DESCRIPTION
1. Input Socket.
Accepts standard mono ¼ inch guitar instrument cable.
2. Input level switch.
This switches the input sensitivity. 0dB with passive pickups or -10dB: output from an
additional pre amp.
3. Level Control.
Controls volume of amplifier.
4. Bass Control.
5. Mid Range Control.
6. Treble Control.
7. FX Send.
Connect the FX send to auxiliary FX unit input.
This can also be used as an additional line out if necessary.
8. FX Return.
Connect the FX Return to auxiliary FX unit output.
9. Line Out.
These are used for driving a second amplifier.
10. Tuner Out.
Connect to instrument tuner. This output can also be used as an additional line out.
11. XLR Balanced Line Out.
This is an ultra-low impedance (200ohm) balanced line out for use with recording or PA
mixing consoles.
12. Ground lift Switch.
When there is a difference in grounding between audio equipment, it can cause what is
known as a ground loop. This will cause an audible hum or buzz through the speakers or
main PA speakers. Using this switch will break the ground loop and therefore eliminate
any hum.
13. AC Power On/Off Switch.
14. AC Power input and AC fuse holder.
Connects the amplifier to AC power supply. Always use a grounded plug and make sure
the AC cable is more than 3A rating at 250-volt AC. If you require a longer AC power
cord, we recommend you use the AAD heavy-duty 20 foot power cords. These are
available as an accessory. Use a slow blow ¾ inch fuse rated at 2.5 amps.
5