Radio, Ipod/iphone/ipad operations bluetooth, Remote control messages – Panasonic SCHC38EC User Manual

Page 12

Advertising
background image

12

RQT9746

A beat sound or noise is heard while receiving
radio broadcast.

≥ Adjust the position of the antenna.
≥ Try to keep a certain amount of distance between the antenna and

AC mains lead.

≥ Try using an outdoor antenna if there are buildings or mountains

nearby.

≥ Switch the television or other audio players off or separate it from

this unit.

≥ Keep this unit away from mobile phones if the interference is

apparent.

Cannot charge or operate.

≥ Have you selected the appropriate selector?

Press [iPod] to select either “IPOD_DOCK” or “IPOD_PORT”.

≥ Check that the iPod/iPhone/iPad is connected properly. (

l 6)

≥ The battery of the iPod/iPhone/iPad is depleted. Charge the iPod/

iPhone/iPad, and then operate again.

≥ Connect the iPod/iPhone/iPad again or try to restart the iPod/

iPhone/iPad.

≥ When this unit is in standby mode, charging will not start when

using the “IPOD_PORT” connection.
Turn this unit on and make sure the charging has started before
switching this unit to standby mode.

Pairing cannot be done.

≥ Check the Bluetooth

®

device condition.

The device cannot be connected.

≥ The pairing of the device was unsuccessful or the registration has

been replaced. Try pairing the device again. (l 7)

≥ This unit might be connected to a different device. Disconnect the

other device and try pairing the device again. (l 7)

The device is connected but audio cannot be heard
through this unit.

≥ For some built-in Bluetooth

®

devices, you have to set the audio

output to “SC-HC38” manually. Read the operating instructions for
the device for details.

The sound is interrupted.

≥ The device is out of the 10 m communication range. Bring the

Bluetooth

®

device closer to this unit.

≥ Remove any obstacle between this unit and the device.
≥ Other devices that use the 2.4 GHz frequency band (wireless

router, microwaves, cordless phones, etc.) are interfering. Bring
the Bluetooth

®

device closer to this unit and distance it from the

other devices.

≥ Select “MODE 1” for stable communication. (

l 7)

The remote control doesn’t work properly.

≥ The remote control and this unit are using a different code.

(l 13, “REMOTE ”)

≥ Is the battery depleted or is the battery inserted incorrectly? (

l 4)

The following messages or service numbers may
appear on the unit’s display.

“--:--”

≥ You plugged the AC mains lead in for the first time or there was a

power failure recently. Set the time (l 10).

“ADJUST CLOCK”

≥ Clock is not set. Adjust the clock accordingly.

“ADJUST TIMER”

≥ Play timer is not set. Adjust the play timer accordingly.

“AUTO OFF”

≥ The unit has been left unused for about 30 minutes and will shut

down within a minute. Press any button to cancel it.

“CANNOT SET”

≥ Select an audio source other than “BLUETOOTH”.

“CHECKING CONNECTION”

≥ The unit is checking the connected iPod/iPhone/iPad.
≥ If this display keeps appearing, make sure that the battery of the

iPod/iPhone/iPad is not depleted and that the iPod/iPhone/iPad is
turned on and connected correctly (l 6).

“ERROR”

≥ Incorrect operation is performed. Read the instructions and try

again.

“F

” (“ ” stands for a number.)

≥ There is a problem with this unit.

Note down the displayed number, disconnect the AC mains lead
and consult your dealer.

“ILLEGAL OPEN”

≥ Sliding door is not in correct position. Turn the unit off and on

again. If this display appears again, consult the dealer.

“IPOD_DOCK OVER CURRENT ERROR”
“IPOD_PORT OVER CURRENT ERROR”

≥ The iPod/iPhone/iPad is drawing too much power. Disconnect the

iPod/iPhone/iPad and turn the unit off and on again.

≥ The USB device is drawing too much power. Switch to “CD”

mode, remove the USB and turn the unit off.

“NODEVICE”

≥ The iPod/iPhone/iPad device is not inserted correctly. Read the

instructions and try again (l 6).

≥ The battery of the iPod/iPhone/iPad is depleted. Charge the iPod/

iPhone/iPad and turn it on before connecting.

≥ The USB device is not inserted. Check the connection.

“NO DISC”

≥ Insert the disc to be played (

l 6).

Radio

≥ Confirm the antenna is properly connected. (

l 5)

iPod/iPhone/iPad operations

Bluetooth

®

Remote control

Messages

SC-HC38_EC~RQT9746-R.book 12 ページ 2012年12月28日 金曜日 午後6時53分

Advertising