Fitting procedure, Anchoring the plasma tv, Connecting additional components – Panasonic TYWK6P1RW User Manual
Page 8
8
English
6. Mounting the plasma TV onto the wall-
hanging bracket and connecting it to
the other components
Cutout at top
Insulation spacer at bottom
Hole at bottom
Surface of wall
Surface of wall
Notes
• Connect the cables and cords of the connecting components
before mounting the plasma TV to the wall-hanging bracket.
• When mounting the plasma TV to the wall-hanging bracket, make
sure that cables and cords do not get pinched between the plasma
TV and the wall-hanging bracket.
• Refer to the plasma TV instruction manual for connecting the
plasma TV to the other components.
Fit the insulation spacers at the top of the plasma TV onto
the cutout at the top of the wall-hanging bracket.
Slowly lowering the plasma TV, insert the insulation spacers
at the bottom into the holes at the lower part of the wall-
hanging bracket.
Now lower the plasma TV.
CAUTION
• If the plasma TV is lifted too much, its top part will become
disengaged from the wall-hanging bracket.
Hole for mounting the screw
for securing unit
M5 × 50 Screw for securing unit
Wall-hanging bracket
Surface of wall
7. Anchoring the plasma TV
Install the accessory screws for securing unit (2) into
the mounting holes of the screws for securing unit on the
sides (left and right) of the wall-hanging bracket.
Note
• In order to prevent the plasma TV from becoming disengaged
from the wall-hanging bracket, the screws for securing unit
must be securely tightened at the left and right as far as their
bases.
Connecting additional components
Remove the left and right red-marked screws (one at the
left and one at the right) used to anchor and release the
plasma TV.
Lifting the plasma TV slightly and pulling it forward, pull out
the insulation spacers at the bottom.
Pull the plasma TV forward, and connect the connecting
components’ cables or cords to the terminals on the back.
Lifting the plasma TV slightly, insert the bottom insulation
spacers into the holes at the lower part of the wall-hanging
bracket.
Now lower the plasma TV.
Securely tighten the left and right red-marked screws (one
at the left and one at the right) used to anchor and release
the plasma TV in the red-marked screw mounting holes on
the side of the wall-hanging bracket.
(Tightening torque: 1.2 to 1.5 N•m)
Red-marked screw
used to anchor and
release the plasma TV
Hole at
bottom
Insulation spacer at
the bottom
Red-marked screw
used to anchor and
release the plasma TV
Surface of wall
Surface of wall
Note
• When connecting components to the plasma TV, ask a qualified
installation specialist.
Fitting procedure