Fitting procedure, Adjusting the angle of the wall-hanging bracket, Preparing the plasma display – Panasonic TYWK42PR20 User Manual
Page 14: English
14
English
Screw the bracket into position using the screws at the
remaining two screw holes at the top.
Use the angle adjustment screws, which were removed, to
perform the angle adjustment of step 4.
4. Adjusting the angle of the wall-hanging bracket
The angle of this wall-hanging bracket can be adjusted in 5-degree increments to one of five positions ranging
from “Zero tilting” to “20-degree tilting”.
The wall-hanging bracket is shipped from the manufacturing plant in the “Zero tilting” angle position. To change
the angle, use the angle adjustment screws to change the position of the stay.
(Tightening torque: 1.2 to 1.5 N•m)
When the angle is set
to “Zero tilting”
Angle
adjustment
screws
Surface of wall
When the angle is set
to “15-degree tilting”
Surface of wall
Note
• When using some types of HDMI cables (RP-CDHG80 or RP-CDHG100) or PC cables, the cable may touch the wall and cause
damage to the HDMI terminal or the PC input terminal on the plasma display.
In such a case, adjust the angle of the wall-hanging bracket so that no weight is applied to the cable.
5. Preparing the plasma display
Attaching the insulation spacers
Place the front surface of the plasma display on a clean
cloth that has no dirt or foreign objects on it, and follow the
procedure below.
If the plasma display has any protruding parts, take care not to
scratch or damage them.
Remove the four caps from the plasma display using a Phillips
head screwdriver.
Note
• Keep the caps that were removed in a safe place.
(They will be required if you use the pedestal.)
Using the supplied Allen wrench , mount the supplied 4 Allen
head countersunk screws , 4 dished toothed washers and
4 insulation spacers at the locations where the caps were
removed as shown in the figure on the right.
(Tightening torque: 3 to 4 N•m)
Fitting procedure
Phillips head screwdriver
Blanket
Cap
Blanket
“20-degree tilting”
“Zero tilting”
Stay
“Zero tilting”
“Tilting from 5 to
20 degrees”
“15-degree tilting”
“10-degree tilting”
“5-degree tilting”