Panasonic TH50PF50E - Manual (Page 8)

8
English
Accessories
+
-
+
-
Accessories Supply
Power supply cord Clamper × 1
TMME289
• Operating Instructions
Display Operations
Network Operations
• Software license statements
GNU GENERAL PUBLIC
LICENSE
GNU LESSER GENERAL
PUBLIC LICENSE
Ferrite core × 2
J0KG00000014
Batteries for the Remote
Control Transmitter
(R6 (UM3) Size × 2) Remote Control
Transmitter
N2QAYB000691 Operating
Instruction book
Check that you have the accessories and items shown
Remote Control Batteries
Requires two R6 batteries.
1. Pull and hold the hook, then open
the battery cover.
2. Insert batteries - note correct
polarity ( + and -).
3. Replace the cover.
Use the Ferrite cores to comply with the EMC standard.
(See page 11)
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
7. Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
“R6 (UM3)” size
CD-ROM Ч 1