Panasonic TC-32A400U - Manual (Page 13)

First T
ime Setup
|
Operating the TV
13
English
hod
box
used
6
Select [Auto program] and start
scanning
Auto program
Yes No
Start scanning for available channels in your area?
Auto scan may take 20 minutes or more to complete.
OK
OK
Select
Scanning in progress...
Auto program
Progress
This may take some time to complete.
Press RETURN to quit
Number of analog channels
Number of digital channels
4%
3
0
Auto program completed.
Press OK to continue.
Number of analog channels
Number of digital channels
10
0
First Time Setup completes when scanning is done.
Congratulations!
Setup is complete.
Enjoy your Panasonic VIERA TV.
Press OK to exit.
ANTENNA/Cable In is selected.
OK
RETURN
Press OK to exit.
To watch TV via a Cable box, Satellite receiver, or any
other source (DVD, DVR, gaming device, etc.), press the
INPUT button and select the appropriate input (p. 15).
Note
● If you turn off the TV by pulling out the power cord
before completing “First Time Setup”, “First Time
Setup” will launch again when you next turn on the
TV.
On the other hand, if you turn off the TV with the
POWER button on the TV or remote control, this
procedure will not launch again on your next power on.
● You can repeat “First Time Setup” by selecting [Reset
to defaults] in the [Setup] menu (p. 21).
● After “First Time Setup”, you can change [Language]
from the [Setup] menu (p. 21) or retune the TV
using [Auto program] or [Manual program] (p. 22).
Operating the TV
Using the TV controls
CH
INPUT/
HOLD
for
MENU
VOL
OK/
1
2
3
4
Indicators on the TV
5 6
1 Changes the input mode
Chooses Menu and Submenu entries
Press and hold for 3 seconds for MENU
function
●
Press again and hold for 3 seconds to return to
the previous screen from submenus / exit from
main menu page.
2 Selects channels in sequence
Makes selections or adjustments when in the
menu system
3 Volume Up / Down
Makes selections or adjustments when in the
menu system.
4 Power button
● Switches TV On or Off (Standby).
●
To completely turn off the TV, remove the power
plug from the wall socket.
5 Remote control signal receiver
●
Remote control sensor range is about 23 feet
(7 meters) in front of the TV set.
6 Power LED
● On: Red
Off: No light
● The TV consumes a small amount of electric
energy even when turned off.
Note
●
Do not place any objects between the TV remote
control signal receiver and remote control.
TC-32_39A400U_EN.indd 13 TC-32_39A400U_EN.indd 13 12/20/2013 5:18:57 PM 12/20/2013 5:18:57 PM