Panasonic SC-NT10D - Manual (Page 10)

VQT5A86
10
You can change the transmission speed to prioritize sound quality or
connectivity.
• The default setting is “Sound Quality Priority MODE”. When the sound is interrupted, select
“Connectivity Priority MODE”.
1 Set either of the following modes.
∫ Sound Quality Priority MODE:
While pressing and holding [ ], press and hold [VOL -] until
the Bluetooth
®
indicator (blue) and the Boost Mode indicator
(orange) blink once.
∫ Connectivity Priority MODE:
While pressing and holding [BOOST], press and hold [VOL -]
until the Bluetooth
® indicator (blue) and the Boost Mode
indicator (orange) blink once.
2 Press [Í/I] to turn this unit off, and press [Í/I] again to turn on.
• The Bluetooth ® connection is automatically established, and the Bluetooth ® indicator (blue)
lights up.
• Turn off this unit or the device.
• Stop / disable the Bluetooth
® transmission of the device.
• (For NFC-compatible devices only)
Touch and hold your device to NFC touch area of this unit again.
Note
• This unit can only be connected to one device at a time.
• This unit can register up to 8 devices. If a 9th device is paired, the device that has not been used for
the longest time will be replaced.
• Even when this unit is turned off, if this unit is connected to the PC that is powered on with an USB
cable and this unit is selected on the device that is paired with this unit, power of this unit will be
turned on and connected via Bluetooth
® automatically.
• If the image and sound are out of sync during playback, restart the playback app you are using. If
the problem persists, connect the Bluetooth ® device and this unit with an audio cable.
• The One-Touch Connection may not work properly depending on the type of device being used.
Selecting Transmission mode setting
Disconnecting Bluetooth ®
SC-NT10_VQT5A86_eng.book 10 ページ ２０１３年６月６日 木曜日 午後１２時２２分