Panasonic EYFLA6P - Manual (Page 8)

- 8 -
. To remove the battery pack:
Push up on the button from the front to re-
lease the battery pack.
Button
V
.
OPERATION
Before Using the Remote
Control (Available as an
optional accessory)
Insert the battery
1. Pull out the battery holder.
1
Push in on the fas-
tener as indicated by
the arrow.
2 Pull out the holder.
. Insert the battery and
push the holder
back in.
NOTE:
• If the tool does not respond to the wire-
less remote control even when the remote
control is operated close to the tool, the
battery (CR05) is dead. Replace it with
a fresh battery.
• The included battery is provided for sample
use and may not last as long as commer-
cially available batteries.
Wireless remote control range
Approx. 50 cm
Vertically
Ap
pro
x. 6
0°
Approx
. 60
°
The remote control should be operated within
approximately 50 cm and approximately 60°
vertically and horizontally of the perpendicular
relative to the infrared Assembly Qualifier on
the tool.
• Under the following circumstances, you may
not be able to operate the tool, even within
this range.
• If there is an object between the remote
control’s transmitter and the tool’s Assem-
bly Qualifier.
• Use outdoors or in other environments
where the remote control Assembly Qualifier
is exposed to a strong light source, or when
the remote control transmitter or Assembly
Qualifier is dirty may cause the tool to fail to
respond, even when the remote control is
used within the operating range.
[Main Body]
Switch and Forward/Reverse
Lever Operation
Forward Reverse
Switch lock
CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit comes
to a complete stop.