AllerAir 6000 Series - Manual (Page 3)

REPLACING HEPA AND/OR CARBON FILTERS
3
Step 10
Replace the base, making sure the
arrow on the gold sticker lines up
with unit's rear seam.
Step 11
Replace the four screws.
Step 12
Turn the unit back onto its
wheels. It is now ready for use.
Step 9
Put back the felt pad
removed in STEP 4.
STEP 1
STEP 2
STEP 3 Make sure the unit is set to
"off" and the unit is unplugged.
Place the unit upside down,
so that the wheels face up.
Using a #2 Philips screwdriver,
remove the four screws that
hold the base onto the unit. Grasp the wheels. Remove
the base by pulling gently
on the wheels
STEP 4
Reach inside the unit, and
remove felt pad.
STEP 5
STEP 6
STEP 7
First, remove the carbon filter.
(pull up gently by placing thumbs
on the inner side of the filter)
Then, remove the HEPA filter
with the same technique.
Now, place the new HEPA
filter into the unit.
STEP 8
Then, place the new
carbon filter into the unit.
See page 5 for instructions on
replacing carbon filling.
NEW
HEPA NEW
CARBON
AllerAir Industries Inc. Toll free: 1-888-852-8247 / Fax: 1-877-688-2193 www.allerair.com
6
AllerAir Industries Inc. Toll free: 1-888-852-8247 / Fax: 1-877-688-2193 www.allerair.com
FILTER
ASSEMBLY
D, DS and DX
Step 1
Make sure the unit is set to "Off,"
and unplug it. Lay the unit upside
down, so that the wheels face up.
Step 2
Using a #2 Philips screwdriver,
remove the four screws that hold
the base onto the unit.
Step 7
Replace the base, making sure the
arrow on the gold sticker lines up
with unit's rear seam.
Step 8
Replace the four screws.
Step 9
Turn the unit back onto its wheels.
It is now ready for use.
Step 3
Grasp the wheels. Remove the base
by pulling gently on the wheels.
Step 5
Gently insert the carbon filter
(either a Model D, DS or DX
Carbon) into the unit, either end
Step 4
Reach inside the unit, and remove
only 1 of the 2 felt pads.
Step 6
Put back the felt pad removed in
STEP 4.
A Message for the Client
NEW
CARBON
The model you have selected is shipped in 2 separate boxes to protect certain
components. The filter comes in one box, and the outer shell of the unit,
containing the motor and the fan, comes in another. Filters must be installed
before turning the unit on in order for it to work. AllerAir technicians
recommend removing the base, installing the filter, and replacing the base
according to the following steps: