Panasonic EY7410LA1C - Manual (Page 7)

- 7 -
Reference for Adjusting Torque
Setting Torque Use
1
Approx: 0.9 N·m
(3.0 kgf-cm or .6 in-lbs)
For driving
screws
5
Approx: 0.8 N·m
(8.4 kgf-cm or 7.3 in-lbs)
9
Approx: 1.35 N·m
(13.8 kgf-cm or 1.0 in-lbs)
13
Approx: 1.88 N·m
(19. kgf-cm or 16.6 in-lbs)
17
Approx: .41 N·m
(4.6 kgf-cm or 1.3 in-lbs)
1
Approx: .94 N·m
(30.0 kgf-cm or 6.0 in-lbs)
Approx: 4.4 N·m
(45.0 kgf-cm or 39.0 in-lbs)
For power-
ful driving
screws and
drilling
● When using at high speeds, set the
clutch at 10 or below. (Operation
stops at the maximum torque of 1.5
N·m (15 kgf-cm) when the scale is
higher.)
● The auto shut-off function may be-
come inoperable at higher clutch
settings when battery power drops.
Recharge the battery in that case.
NOTE:
The chart is only a reference. The
torque settings may differ by materi-
als, types of screws, etc. Please test
it at your own conditions before use.
 Battery Low Warning Lamp
<Battery low warning lamp>
Off
(normal
operation)
Flashing
(No charge)
Battery
protection
feature active
Excessive (complete) discharging of
Li-ion batteries shortens their service
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
● The battery protection feature acti-
vates immediately before the bat-
tery loses its charge, causing the
battery low warning lamp to flash.
● If you notice the battery low warn-
ing lamp flashing, charge the bat-
tery pack immediately.
 Using the LED Light
Use the LED light on jobs in dark
locations such as attics to illuminate
your workspace.
CAUTION
● The LED light is intended for use as
a supplemental light source. Do not
use it as a flashlight.
Doing so may result in accident or
injury.
● Do not look at the light or shine it
directly into your eyes.
Continuous exposure to the LED
light may damage your eyes.
1. Press to toggle the light on
and off.
● To use the light immediately after
attaching the battery pack or after
the drill has not been used for 5
minutes or more, operate the drill
briefly.
● The light will automatically turn
off if the drill is not used for 5
minutes.
● The light uses an extremely small
amount of current. Using the light
EY7410(UL).indb 7 2006/09/08 17:30:52