ADTRAN T-BR1TE - Manual (Page 2)

CORPORATE OFFICE
901 Explorer Boulevard
Huntsville, AL 35806
800 9ADTRAN
Local: 256 963-8000
Fax: 256 963-8699
Fax Back: 256 963-8200
http://www.adtran.com
email: [email protected]
TELCO TECHNICAL
SUPPORT
800 726-8663
REGIONAL OFFICES
Irvine, CA
800 788-5408
Denver, CO
800 471-8651
Atlanta, GA
800 332-6945
Kansas City, KS
800 471-8649
Philadelphia, PA
800 471-8656
Dallas, TX
800 471-8648
Canada
800 232-6811
ADTRAN is an ISO 9001
registered company.
Printed in U.S.A. on recycled paper
61100.019L1-8F May 1998
©ADTRAN, Inc. 1998
Product Specifications
LOOP INTERFACE
■ Line: 4-wire (Tx and Rx pair)
■ Operating Mode: Full-duplex
■ Data Rate: 192 kbps total; 144 kbps
available to customer
■ Signal Format: Alternate Mark Inversion,
100% pulse width
■ Output Amplitude: 0.75 volt, zero-to-peak
■ Tx Source Impedance: Per ANSI
T1.605-1992
■ Rx Source Impedance: Per ANSI
T1.605-1992
■ Receiver Sensitivity: Per ANSI T1.605-1992
DS1 FACILITY INTERFACE
■ Fully compatible with WECO D4 channel
bank equipment
NETWORK COMPATIBILITY
■ Interface: ISDN and other digital service
FACEPLATE CONTROLS AND INDICATORS
■ Controls: B1/B2, LP/CR, Select, Test
■ Indicators: Four-character display is used
to select loopback address and display
loopback status
■ Test: Bantam test jacks for TPI 108/109 RT
II or equivalent test sets
MECHANICAL
■ Size: 4.4" H, 10" D, 1.4" W
■ Weight: 10 oz
■ Mounting: Mounts in WECO D4 channel
bank, SLC-96 terminals, ADTRAN ACT and
BR1/8 BR1TE Bank
POWER
■ –48V: 250 mA, 1.35 watts dissipation (when
supplying a maximum of 12 watts to
terminal equipment)
■ +12V: 45 mA nominal
■ –12V: 1 mA
■ 5V:
— 10 mA Display OFF
— 45 mA Display ON
Ordering Information
EQUIPMENT PART #
T-BR1TE ................................................1100019L1
BR1/8 BR1TE Bank..............................1150018L1
Specifications subject to change without notice.