Panasonic EY3641 - Manual (Page 8)

- 8 -
5) Set the nozzle and install the front cap
on the tube holder. (Fig. 7)
6) Push the rack until touching the
cartridge. (Fig. 8)
For use with sausage pack
1) Cut off the tip of nozzle at a point
suitable for the job. (Fig. 3)
) Pull the rack all the way to rear.
(Fig. 4)
3) Unscrew the tube holder from the
housing.
4) Screw sausage pack adapter on to
piston joint. (Fig. 9)
NOTE:
• Make sure that the plunger rotates
smoothly.
5) Install the tube holder on the housing,
remove the front cap from the tube
holder, and insert the sausage pack.
(Fig. 10)
6) Set the nozzle and install the front cap
on the tube holder. (Fig. 11)
7) Push the rack until touching the
sausage pack. (Fig. 1)
IV
.
OPERATION
How to use the sealing
gun
1) Hold the grip while holding the tube
holder. (Fig. 13)
) Set the nozzle in the groove, then
squeeze the switch (L). The rack will
move forward.
3) The tube holder can be rotated. This
makes sealing application even easier
in hard-to-work places.
4) Set rack speed according to work.
You can easily change speeds while
working by rotating application speed
control (K) by finger.
CAUTION:
• Be sure to lock the trigger (“0” position)
when finished working.
Speed rate adjustment
0 1 Slow Fast 5
Lock
5) The rack will retract slightly when you
release the trigger, so as to prevent
dripping.
CAUTION:
• Dripping can occur with small nozzle
openings or exceptionally soft sealing
compounds.
6) You can pull the trigger repeatedly to
dispense small shots of compound.
As long as you pull the trigger within
1 second of each shot, the rack will
move forward slowly without retracting.
For hard compounds
• Warm the sealing compounds until the
compounds become soft.
• Slow down the speed by selecting the
application speed control.
• Make the nozzle cut diameter bigger.
(Fig. 14)
CAUTION:
• Make sure the front cap is tightened
securely when working.
• Do not touch the rack to avoid getting
your fingers pinched.
• Use the tool only for its intended purpose,
and do not operate it for long periods of
time without interruption, since this may
damage the sealing gun or cause the
cartridge to jam. Do not insert a cartridge
if it is wet, or if the sealing compound has
hardened.
• If the tool is operated for long periods of
time, the motor may overheat.
It is therefore recommended to switch it
off from time to time.
• The use of flammable materials, even for
cleaning purposes, is not permitted.