Panasonic DMWFL500E - Manual (Page 11)

11
VQT0Z62
Checking the Flash’s
Remaining Battery Charge
≥ Install the batteries and then turn on the unit
and check the battery remaining power.
1 Push the [POWER] button.
≥ Charging now starts.
2 Check that the [TEST/CHARGE]
button lights.
≥ After the batteries have been fully
charged, the [TEST/CHARGE] button
lights.
≥ If it takes as long for the [TEST/CHARGE]
button to light as the period indicated in
the table below, it means that the
batteries are nearly worn out. Replace
them with fresh batteries as soon as
possible.
≥ If the [TEST/CHARGE] button and [AUTO
CHECK] lamp both flash at the same
time, it means that the batteries are
almost completely worn out and should
be replaced with fresh batteries as soon
as possible.
3 Push the [POWER] button to turn
off the unit’s power.
≥ When the [TEST/CHARGE] button is pushed,
the unit may fire.
≥ Turn off the power in the following situations:
≥ When mounting the unit onto, or disengaging
it from, the digital camera
≥ When you do not want the unit to fire
≥ When you are not going to use the unit
Alkaline batteries More than
30 s
Rechargeable nickel metal
hydride batteries More than
10 s
POWER POWER
TEST/
CHARGE
VQT0Z62.book 11 ページ ２００６年６月２２日 木曜日 午前１１時４６分