Care & cleaning – Panasonic CURE18HKE User Manual
Page 6
6
Remove
Remove
Remove
Remove
CARE & CLEANING
CARE & CLEANING
• Switch off the power supply before cleaning.
• Do not touch the aluminium fi n, sharp parts may cause injury.
WASHING INSTRUCTIONS
WASHING INSTRUCTIONS
• Do not use benzene, thinner or scouring powder.
• Use only soap ( pH7) or neutral household detergent.
• Do not use water hotter than 40°C.
HINTS
HINTS
• Clean the fi lter regularly for best performance and to
reduce power consumption.
• Please consult your nearest dealer for seasonal
inspection.
CAUTION
INDOOR UNIT
INDOOR
UNIT
Wipe the unit gently with a soft, dry cloth.
ALUMINIUM FIN
ALUMINIUM
FIN
Raise and pull to remove. Wash gently and dry.
FRONT PANEL
FRONT
PANEL
AIR FILTERS
AIR
FILTERS
• Air fi lters cleaning is needed every two weeks.
• Wash/rinse the fi lters gently with water to avoid damage
to the fi lter surface.
• Dry the fi lters thoroughly under the shade, away from fi re
or direct sunlight.
• Replace any damage fi lter.
• Vacuum the fi lter whenever necessary.
• Replace the fi lter every 10 years or replace any
damaged fi lter.
Part no.: CZ-SA16P
SUPER ALLERU-BUSTER FILTER
SUPER
ALLERU-BUSTER
FILTER
Vacuum the super
alleru-buster fi lter.
FOR SEASONAL INSPECTION AFTER EXTENDED
FOR SEASONAL INSPECTION AFTER EXTENDED
NON-USE
NON-USE
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• After 15 minutes of operation, it is normal to have the following
temperature difference between air inlet and air outlet vents:
Cooling: ≥ 8°C
Heating: ≥ 14°C
NON SERVICEABLE CRITERIAS
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY then CALL Authorized
Distributor under the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
FOR EXTENDED NON-USE
FOR EXTENDED NON-USE
• Activate Heat mode for 2~3 hours to remove moisture left in
the internal parts thoroughly.
• Turn off the power supply.
• Remove the remote control batteries.